Installations: 10 Mistakes that Most People Make

How To Repair a Garage Door The first step to installing a new garage door is removing the old door, using the instructions provided by the door manufacturer, carefully remove the old door, this consists mainly carefully unlatching the door from the pulley system, then the panels of the door are taken apart and then unscrewing the tracks, care should be taken so that the panels do not fall on you by making sure only one panel is removed at a time The areas where the door is supposed to be installed are then measured, these are; the door-opening height and width, the headroom from the top of opening to ceiling, and the back room which is the length of the garage, having done the proper measurements, the stops temporarily attach to both sides of the opening, making sure they are flush with the inside edge of the door jamb, the bottom piece of the new door is laid out using the sawhorses, if necessary any required weather stripping is attached, any hinges that are necessary are additionally attached and handles lifted to piece Next, using a level in order to set the piece properly, the bottom piece is inserted into the frame of the door, after the piece is set in place, the tap nails partway into each jamb, the nails are bent slightly or slant so that they are secure in place, then using the manufacturer’s instruction, the vertical, curved and horizontal pieces of the track are assembled and then set aside The second panel is then installed on top of the first one, nails are then hammered into the side jambs so that they are well held in place, hinges are the next installed, then the process is repeated according to the number of panels that are necessary, however, it is a requirement that each of the pieces is anchored into the door jamb, this marks the completion of the fourth step undertaken when installing a garage door
Lessons Learned About Services
upon securing all sections, rollers are installed in the section that supports the rollers, upon completion, the rollers are then placed in the pre-assembled track, the tracks brackets are secured in the process, it is a precaution measure not to press the rollers too tightly against the track, this is because the friction that may result is harmful
Lessons Learned About Services
after securing the vertical tracks against the jambs, the horizontal and curved pieces are installed next, previous measurements are used during installation of the horizontal pieces, the tracks should be straight and point 90 degrees away from the opening, springs are then assembled according to manufacturer’s instructions, in order to make the tracks level and parallel, the door is lifted to about half length, in order to attach springs to the pulley, the door is lifted up the remaining distance, that is how a new garage door is opened